Panel menu

The Panel menu of AB Commander offers the following commands that you can use to control the appearance of the file panels:

Switch to opposite Panel

Activates the passive panel. You can also press the Tab key to activate the opposite panel.

Switch to/from Folders

Activates the folder bar. You can also press the Shift+Tab keys to switch the input focus to the folder bar.

Show - Folder bar

Toggles the folder bar of the active panel.

Show - Toolbar

Toggles the panel toolbar of the active panel.

Show - Drive bar

Toggles the panel drive bar of the active panel.

Customize Panel Toolbar

Opens the Customize Toolbar window for the toolbar of the active panel.

Reset Panel Drive bar

Resets the panel drive bar of the active panel.

Save tabs

Saves the tabs of the active panel into a file of your choosing.

Load tabs

Loads the tabs from a file into the active panel.

Store columns

Remembers the current set of the columns displayed in the active panel, for use by the Restore columns command. (This command is available with Windows Vista (and later) only, and only for the file system folders). More information...

Restore columns

Restores the columns of the active panel as they were the last time you used the Store columns command. (This command is available with Windows Vista (and later) only, and only for the file system folders). More information...

Set Filter

Opens the Filter window for the active panel.

Remove Filter

Removes filter from the active panel.

Maximize/Split

Maximizes the active panel; or, if it is already maximized, restores the original split position.

Split Vertically

Tiles the panels vertically.

Split Horizontally

Tiles the panels horizontally.

Swap panels

Swaps the panels so that each panel takes the other's place.

Refresh

Refreshes the contents of the active panel.